What Are The Standards And Items Of Shoe Machine Operation?

All kinds of shoe machine items and operation standards:

One

Check the power switch, put the mold in the middle of the bottom, fix the left and right position, press the on green key switch first, right foot step on the foot switch again, press the red key to indicate the boot, then give the machine routine maintenance.

The 2. is to cut the middle sole, the big bottom machine: adjust the distance between the cutter and the backboard according to the different numbers, adjust the distance between the blade and the backboard, and the width of the bottom end is short and narrow.

Turn green in the direction of on and turn off in the direction of off, and record daily maintenance and regular maintenance.

Three

First, add the necessary anchor to inspect the belt switch and the power supply department.

Fixing the location of the nail in the middle of the seven character iron bar with different size, press the green switch and pedal on the foot switch, and press the red to turn off the machine for daily maintenance.

4., the machine is to check the switching power supply, fix the movable ruler of different size, tighten the iron bar with the bottom and upper bottom movable disc and the fixed bottom die. According to the plane green switch, the time and pressure are 5 seconds and 18 kilograms respectively. The safety runaway device should be checked at any time, and the switch is switched on by the red switch for daily and regular maintenance.

5. grinding machine: the sand cloth stuck to the rubber wheel must be fastened. When the machine is installed, the screws are tightened, the vacuum cleaner and the power switch are checked, the green switch is switched on in the on direction, and the machine is turned off to off direction for routine maintenance.

6.. On trimming machine: check the vacuum cleaner, power switch and belt. When you change the knife, gently pull the belt with your hands. The knife can't touch the lower push wheel. Look at the distance from the bottom adjustment knife to the on direction, turn off the machine to make the routine maintenance.

7.. 5~6 press machine: check the power switch, the general pressure is about 20 kg, the time is 5~6 seconds, fixed standard press die, press the green key to twist, use foot pedal switch, turn off press the red key, make daily and regular maintenance.

Eight

To secure a solid saw blade, first install the upper flywheel, then install the following wheel, turn the upper wheel lightly with the hand, adjust the tightness, and check the switch well, then switch on the air switch, switch off and turn off the machine for routine maintenance.

9.. Grinding machine: check the switch, the vacuum cleaner, the wheel is damaged, the gasket should be leveled, then the grinding wheel is screwed up with the screw upper gasket. If necessary, the sound is not correct. Immediately, wrap the paper on the center shaft to prevent the wheel from shaking. Press green to turn on the machine and turn off the machine to make routine maintenance.